Slings and shackles in the UAE are the rigging gear that connects a load to a crane or hoist hook: chain, wire rope and synthetic slings, and bow and dee shackles. This page explains the types, how working load limits and certificates work, what UAE sun and coastal air do to them, and how to compare suppliers.
0 suppliers found
Skip the search. Post your requirement and we'll connect you with verified slings & shackles suppliers who quote for your order directly.
Tell us about slings & shackles in UAE and receive competitive quotes from verified suppliers — free, fast, and no obligation.
A sling is a flexible strap, chain or rope that wraps or hooks a load, and a shackle is a U-shaped fitting with a pin that links slings, hooks and lifting points. Together they are the rigging accessories in lifting equipment for UAE sites, and they are used on every lift whether the crane is a mobile crane, an overhead crane or a simple hoist.
| Type | Typical UAE use | What to specify |
|---|---|---|
| Chain sling | Rough steel, castings and hot work, where cuts would damage a textile sling | Chain grade, leg count, end fittings, temperature limits, WLL by angle |
| Wire rope sling | General construction, fabrication and marine lifting | Rope construction, diameter, eye type, length, WLL and termination |
| Web sling or flat sling | Finished surfaces, painted steel and machined parts | Width, length, ply, colour code and sewn label |
| Round sling | Delicate loads and pipe | Capacity, cover condition, length; sunlight and chemicals sensitivity |
| Bow and dee shackles | Joining slings to lifting eyes, hooks and spreaders | Pin type (screw or bolt), grade, WLL, size, thread and marking |
| Hooks, rings and links | Master links and end fittings | Grade, WLL, latch, traceability |
The link between load and crane also includes spreader beams and below-the-hook devices such as lifting magnets. Where a hoist is the lifting appliance, see chain hoists and winches.
The working load limit (WLL) is the maximum load a sling or shackle is rated to carry in the stated use, marked permanently on the item. It is lower than the breaking load, which is a multiple of it. Never lift above the WLL, and reduce it when the lifting angle or the type of loading changes.
Kito Crosby gives a concrete example for its G-2130 bolt type anchor shackles: Grade 6, WLL permanently marked on every shackle, a 6:1 design factor, sizes from 3/16 in to 4 in with WLLs from 1/3 t to 150 t, and conformity to ASME B30.26, ISO 2415 and EN 13889, with EN 13889 3.1 certification available for certain sizes. It also rates those shackles for use from minus 40 to 204 degrees Celsius, and refers readers to a separate warnings document for reductions when the shackle is side loaded.
Sunlight and salt are the two UAE problems. Textile slings weaken under ultraviolet light and heat, and steel gear corrodes quickly near the coast. Our lifting equipment page explains the sunlight risk to polyester slings in more detail.
Keep web and round slings in a shaded rigging store, and withdraw any with a faded or unreadable label. A sling left on a yard fence through July is not the same product it was.
Galvanised shackles and hooks resist salt better than plain finishes; keep them dry and oiled in storage. At Jebel Ali, Khalifa Port and Hamriyah check pins and threads for corrosion at every inspection.
Ask the maker for temperature and chemical limits before using slings near hot work or in chemical plants.
Slings and shackles are lifting accessories, and the strictest UAE interval is for accessories. Our lifting equipment page reports that Sharjah requires accessories to be examined at least every 6 months and marked with safe working load and a unique ID, and that Dubai requires EIAC-accredited third-party certification, as checked in October 2026. UK HSE guidance also sets 6 months for lifting accessories unless an examination scheme applies, with a written report showing the examination date and the next due date.
| Requirement | Applies to | Authority |
|---|---|---|
| Third-party examination at least every 6 months, with SWL and unique ID marking | Slings, shackles and accessories in Sharjah | Sharjah Prevention and Safety Authority |
| Test and certification by an accredited third party | Lifting gear in Dubai workplaces | Dubai Municipality (see lifting equipment page) |
| Manufacturer certificate or EN 13889 style certification | New shackles and slings | Supplier and manufacturer |
| Written examination report with next due date | Every examined accessory | Competent person or examiner |
Insist that every delivery arrives with a certificate and a traceable ID, and keep a register so overdue gear is not used.
Choose a supplier who delivers certified, traceable gear and who can arrange examination. Manufacturer-direct supply suits bulk orders and special sling assemblies. An authorised distributor stocks standard grades and certificates. A stockist supplies fast but should still provide documents.
Post your requirement with WLL, lengths, grades and quantities to compare quotes. For the lifting devices these connect to, compare jib cranes and electric hoists.
Price follows material, grade, size, WLL, length, certificate level and finish. Standard shackles and web slings are normally stocked locally, while special lengths, large-capacity shackles and offshore-grade gear are made to order. Quotes that look cheap may omit certificates, so compare on the same specification and documents.
A rigger should check the marking, the condition and the angle before every lift, because a periodic examination does not replace a pre-use look. The checks below take a minute per sling set.
Any item that fails a check is tagged and removed from the store, not left on the rack. Keep rigging in a locked, shaded locker with a register so gear past its examination date is never issued.