Surge Protection Devices Suppliers, UAE

Surge protection devices (SPDs) divert transient overvoltages caused by lightning strikes, switching operations, and power system faults away from sensitive equipment, preventing damage to electronics, control systems, and electrical installations. SPDs are essential in the GCC where thunderstorms, while infrequent, produce severe lightning, and where long cable runs in industrial plants act as antennae for induced surges. Procurement involves selecting the correct SPD type, discharge capacity, and protection level for each zone of the facility.

0 suppliers found

Active:3+ stars API ASME Clear all

No suppliers match these filters

Try clearing some filters — or post your requirement and let matching suppliers come to you.

Request Quotes Clear all filters

Post your requirement, get quotes from multiple suppliers

Tell us about surge protection devices in UAE and receive competitive quotes from verified suppliers — free, fast, and no obligation.

Get Free Quotes

Surge protection devices (SPDs) safeguard electrical and electronic equipment from transient overvoltages that can damage insulation, corrupt data, and destroy sensitive components. In the UAE and Saudi Arabia, SPDs protect against lightning-induced surges (particularly in regions such as Fujairah, Al Ain, and the Saudi Asir highlands that experience thunderstorm activity), as well as switching transients from utility network operations and large motor starting.

SPDs are classified into three types per IEC 61643-11: Type 1 (tested with 10/350 microsecond lightning current waveform) installed at the main distribution board for buildings with external lightning protection systems; Type 2 (tested with 8/20 microsecond waveform) at sub-distribution boards; and Type 3 (fine protection) at the point of use near sensitive electronics. A coordinated multi-stage SPD installation provides comprehensive protection throughout the facility.

Key specifications include maximum continuous operating voltage (Uc, which must exceed the system's maximum steady-state voltage), nominal discharge current (In), maximum discharge current (Imax), voltage protection level (Up, which must be lower than the equipment's surge withstand capability), and backup fuse requirements. For GCC 400/230 V TN-S systems, specify Uc of at least 275 V for line-to-neutral SPDs.

Procurement managers should specify SPDs with visual and remote status indication to enable monitoring of protection status. SPD modules degrade over time and after repeated surge events, so replaceable module designs minimize maintenance cost. For industrial control panels, DCS cabinets, and SCADA systems in GCC process plants, combine power line SPDs with signal line and data line surge protectors on communication cables entering the cabinet. Verify compliance with IEC 61643-11 and request test certificates from accredited laboratories.

Frequently Asked Questions — Surge Protection Devices

Where should SPDs be installed in a GCC electrical distribution system?

Install Type 1 SPDs at the main incoming switchboard (especially if the building has a lightning protection system), Type 2 SPDs at each sub-distribution board, and Type 3 SPDs at sensitive equipment such as DCS cabinets, server racks, and medical devices. This cascaded approach provides coordinated surge attenuation from the service entrance to the point of use.

How do we select the correct SPD voltage protection level?

The SPD's voltage protection level (Up) must be lower than the surge withstand capability of the equipment being protected. Standard electronic equipment typically withstands 1.5 kV (Category II per IEC 60664-1). Select SPDs with Up below 1.5 kV for electronics protection and below 2.5 kV for general circuit protection. Ensure adequate cable distance between the SPD and protected equipment, or use Type 3 fine protection SPDs directly at the equipment.

Do SPDs need replacement after a lightning event?

SPDs with metal oxide varistor (MOV) technology degrade incrementally with each surge event. After a major lightning strike, inspect the SPD status indicators: a red flag or depleted LED indicates the module has reached end of life and must be replaced. Replaceable cartridge-type SPDs allow individual module swaps without rewiring. Schedule annual visual inspections of all SPD indicators as part of the facility's preventive maintenance program.