Gas generators in the UAE are reciprocating engine generator sets that run on natural gas, field gas or biogas, used for continuous industrial power, cogeneration and trigeneration, and power at oil and gas facilities. This page explains how gas sets differ from diesel, what fuel gas data suppliers need, how UAE heat affects output, which approvals apply as of 2026, and how to compare the suppliers listed below.
0 suppliers found
Skip the search. Post your requirement and we'll connect you with verified gas generators suppliers who quote for your order directly.
Tell us about gas generators in UAE and receive competitive quotes from verified suppliers — free, fast, and no obligation.
A gas generator set is a spark-ignited reciprocating engine burning gaseous fuel, coupled to an alternator and controls, and usually built for long running hours rather than occasional standby. Within power generation equipment for the UAE, gas sets fill the gap between diesel generator sets, which suit standby and short-duty prime power, and gas turbines, which suit larger blocks of power.
| Application | Typical UAE setting | Key specification |
|---|---|---|
| Continuous captive power | Factories and industrial zones with a piped gas supply | Electrical efficiency, output at site ambient, availability and service intervals |
| Cogeneration and trigeneration | Hotels, hospitals, campuses, plants with steam or chilled water demand | Recoverable heat from jacket water and exhaust, absorption chiller match |
| Oil and gas field power and compression | Onshore wellsites, gathering stations and camps with produced gas | Tolerance of variable gas composition, hazardous area rating, remote operation |
| Biogas power | Wastewater treatment and landfill sites | Gas cleaning for hydrogen sulphide and siloxanes, low calorific value capability |
| Rental gas power | Temporary or bridging power where gas is available | Containerised modules, connection pressure, mobilisation time |
Where the exhaust and jacket water heat will be used, read the page on cogeneration systems in the UAE; the heat often feeds absorption chillers serving district cooling systems.
Gas generators are cheaper to fuel per kWh where gas is available and are built for continuous running, but they accept sudden load more slowly and depend on the quality and pressure of the gas. Those two points shape most specifications.
Engine makers rate a gas engine for a given gas composition. Heavier hydrocarbons such as ethane and propane in field or associated gas raise the knock tendency, usually expressed as a methane number, and an engine running on low methane number gas may need retarded timing and a lower output. Send the supplier a full gas analysis, the heating value range, hydrogen sulphide content and the supply pressure at the skid, and ask for the guaranteed output on that gas, not on pipeline-quality natural gas.
Kohler's paper on ISO 8528-5 notes that gaseous engines respond slower than diesel engines because of differences in fuel delivery, and its summary of the G3 limits allows a deeper transient frequency dip for gas than for diesel. In practice, a gas set taking a building's load after a blackout needs stepped load transfer, or a diesel set or UPS to carry the first seconds. State whether the set is for continuous base load, island operation or emergency duty.
Turbocharged gas engines hold output well in heat. Wärtsilä's comparison shows its gas engine losing less than 2% of output at 45°C, against a far larger loss for an aeroderivative gas turbine, which is one reason engines suit UAE summer peaks. Still ask for the radiator or cooling tower capacity at your maximum ambient, intake filtration for sand, and enclosure ventilation.
Lean-burn engines run with excess air for higher efficiency and lower NOx; rich-burn engines run near stoichiometric and use three-way catalysts. INNIO's Waukesha range offers both. The choice depends on the emissions limits on your permit and on how the set will be maintained.
Gas generators in the UAE are approved through the facility: the gas connection, the electrical connection, emissions and, on oil and gas sites, hazardous area rules. There is no federal product certificate for the genset itself as of 2026.
| Requirement | Applies to | Authority or reference |
|---|---|---|
| ISO 8528-1 rating and ISO 8528-5 performance class | Generator set specification | Consultant or owner specification |
| Gas supply and connection approval | Pipeline, metering and pressure regulation to the set | Gas supplier or network operator for the site |
| Approval to run in parallel with the grid or export | Captive and cogeneration plants connected to the network | DEWA, Abu Dhabi distribution companies under Department of Energy rules, SEWA, Etihad Water and Electricity |
| Stack emissions reporting | Industrial, energy and oil and gas sources in Abu Dhabi | Environment Agency Abu Dhabi (e-linking system for stack emissions, launched August 2024) |
| ECAS-Ex certificate (IECEx based) | Electrical equipment installed in explosive atmospheres | MoIAT |
| Owner approved vendor list | ADNOC group sites and EPC packages | ADNOC group companies |
On an oil and gas site the gas train, controls and any electrical equipment in a classified zone need hazardous area certification; ECAS-Ex covers electrical equipment used in potentially explosive atmospheres and references the IECEx rules. Confirm with the owner whether IECEx certificates are accepted alongside ECAS-Ex. Synchronising and protection are covered under switchgear and panels.
Gas generators reach UAE buyers through the regional offices and authorised distributors of the engine makers, through packagers that build containerised modules, and through energy service and rental companies that sell power rather than equipment. Most units above a few hundred kilowatts are built to order.
Gas engine and genset brands include INNIO Jenbacher, Waukesha engines for oil and gas duty (335 hp to 5,000 hp according to INNIO), Wärtsilä for large engine power plants, Caterpillar, Cummins, MTU Onsite Energy, Kohler and Himoinsa. Aggreko runs gas-fuelled rental fleets.
Gas generators cost more to buy than diesel sets of the same output, and the case for them rests on running hours, fuel cost and recovered heat. Price depends on electrical efficiency, the gas train and any gas treatment, heat recovery equipment, emissions controls, containerisation and the service contract.
Lead time is usually set by the engine factory and the approvals for the gas and grid connection, which can take as long as manufacture. Equipment typically arrives through Jebel Ali or Khalifa Port. When you want offers from several suppliers, post your requirement with the gas analysis, supply pressure, load profile and heat demand, and use the sourcing guide to check authorisation.
How to size and specify a diesel generator for Gulf sites: kVA and power factor, standby vs prime ratings, heat derating, noise, transfer switches, UAE and Saudi rules, brands and an RFQ checklist.