Automatic Transfer Switches Suppliers, Saudi Arabia

Automatic transfer switches (ATS) provide seamless transition between primary and standby power sources, ensuring uninterrupted electricity supply to critical loads during utility outages. ATS units are mandatory for hospitals, data centers, high-rise buildings, and industrial facilities across the UAE and Saudi Arabia as required by civil defense codes. Procurement decisions should consider transfer time, voltage sensing range, bypass capabilities, and compatibility with the facility's generator system.

0 suppliers found

Active:ASME API ISO 9001 15+ years Clear all

No suppliers match these filters

Try clearing some filters — or post your requirement and let matching suppliers come to you.

Request Quotes Clear all filters

Post your requirement, get quotes from multiple suppliers

Tell us about automatic transfer switches in Saudi Arabia and receive competitive quotes from verified suppliers — free, fast, and no obligation.

Get Free Quotes

Automatic transfer switches (ATS) monitor the primary power supply and automatically switch to a standby generator or secondary utility feed when voltage drops below acceptable thresholds. In the UAE and Saudi Arabia, ATS units are a code requirement for any facility classified as critical, including hospitals, airports, data centers, telecommunications hubs, and high-rise towers.

ATS designs fall into two main categories: open-transition (break-before-make) switches that momentarily interrupt supply during transfer, and closed-transition switches that allow a brief parallel overlap for seamless load transfer. For sensitive facilities such as financial data centers in DIFC or hospital operating theatres, closed-transition ATS or static transfer switches with sub-cycle transfer times are specified to prevent even momentary supply disruption.

Key specifications include rated current (from 100 A to 4,000 A), number of poles (3-pole or 4-pole), transfer time, withstand and closing capacity, and controller intelligence. Modern ATS controllers provide event logging, remote monitoring via Modbus or BACnet, and programmable transfer logic including time delays, voltage and frequency sensing windows, and retransfer conditions.

GCC procurement managers should verify IEC 60947-6-1 compliance and ensure the ATS is rated for the full short-circuit current at the point of installation. For projects in the UAE, DEWA and ADDC require specific ATS configurations depending on the tariff category. Request documentation showing compatibility with your specific generator brand and rating to avoid commissioning delays.

Frequently Asked Questions — Automatic Transfer Switches

What transfer time is acceptable for ATS in GCC data centers?

Standard open-transition ATS units transfer in 200 to 500 milliseconds, which is acceptable for most commercial buildings. Data centers and hospitals typically require closed-transition ATS with less than 100 milliseconds or static transfer switches achieving sub-cycle (less than 4 milliseconds) transfer times to avoid IT equipment resets.

Do we need a 3-pole or 4-pole ATS for UAE installations?

DEWA and ADDC specifications typically require 4-pole ATS units that switch the neutral conductor along with the three phase conductors. This prevents neutral-to-earth voltage issues when transferring between the utility supply and a separately derived generator source. Always confirm with the relevant utility authority for your specific project.

Should the ATS include a bypass isolation switch?

A bypass isolation switch allows the ATS to be taken out of service for maintenance without interrupting power to the load. This is strongly recommended for mission-critical facilities and is often mandatory in GCC hospital and data center specifications. It adds roughly 15 to 20 percent to the ATS cost but prevents planned outages for maintenance.